The Spyder Tarantula™ Diamond Tipped circular saw blade is the durable blade for cutting fiber cement. Polycrystalline diamond (PCD) coated teeth provide clean cuts and exceptionally long life in fiber cement applications – cut fiber cement backer board in the bathroom or exterior trim panels with this durable blade. Track straight with reduced friction, heat and noise – the Tarantula circular saw blade is the professionals choice for cutting fiber cement. Up to 60x the life of standard carbide blades.
- Up to 60x longer lasting than regular blades
- Ultra tough polycrystalline diamond (PCD) coated teeth power through fiber cement
- Anti-friction coating and stabilization vents reduce heat and vibration for reliable cuts
- Diamond-coated cutting teeth provide clean cuts, up to 60x more than standard blades
- Durable diamond cutting teeth and interfused anti-friction coating provide exceptionally smooth cuts
- Polymer-filled stabilization vents reduce noise and vibrations for a straighter cut
- 5/8-in arbor with diamond knock-out
- For use on circular saws with a 10,000 max RPM
- Not recommended for engineered laminate flooring
Watch it Work
To reduce the risk of injury, read the instruction manual and follow the safety regulations of the power tool you will be using with your Spyder accessory. Use personal protective equipment. Always wear eye protection. Protective equipment such as a dust mask, non-skid safety shoes, hard hat and hearing protection should be used in appropriate conditions to reduce the risk of personal injury. WARNING: Operating the tool without wearing proper eye protection may result in serious injury. To reduce the risk of explosion, electric shock, and property damage, always check the work area for hidden gas pipes, electrical wires, and water pipes when making blind cuts. Before each use, check that the blade is clean, sharp and free from cracks, loose teeth, missing teeth, broken teeth, and any other damage. Do not use a dirty, dull, or damaged blade as this may result in blade pinching, binding or stalling, kickback and loss of control. These situations can cause the saw to jump back at the operator and result in a serious injury. Carbide is a hard, but brittle material. Foreign objects in the workpiece such as wire or nails can cause the carbide tips to crack or break. Overheating a saw blade can cause it to warp and result in kickback. Buildup of sap on the blades, insufficient blade set, dullness, and unguided cuts, can all cause an overheated blade and kickback. Always use blades of the correct size with the correct arbor hole shape and size for your power tool. Blades that do not match the mounting hardware of the power tool will run eccentrically, causing loss of control, increasing the risk of personal injury. Make sure the speed marked on the blade is at least as high as the no-load RPM marked on the power tool. To assure proper rotation direction of the saw blade, the arrow direction on the blade must correspond with the arrow direction on the saw. Mount blade properly with the correct blade washers and bolt for the power tool. To reduce the risk of injury, never operate the power tool without proper safety guards in place.