# of Pieces
Stinger™ Brad-Point Drill Bit Set
1/8, 3/16, 1/4, 5/16, 3/8, 1/2″
Spyder Stinger™ brad point bits start fast and produce the cleanest entry/exit holes in soft and hard woods. Optimized cutting geometry reduces cutting friction and heat while dual flute lands ensure holes are straight and burr-free, making this bit ideal for through-holes and installing dowels. Spyder Stinger™ brad point bits drill up to 10x more holes and 6x faster than conventional brad point bits.
- Up to 10x longer life than conventional brad point bits.
- Up to 6x faster than conventional brad point bits.
- Up to 30% longer battery life of cordless tools.
- Patented tip geometry drills faster, virtually eliminates chip burn and produces cleaner entry/exit holes.
- Dual flute lands accurately guide the drill though deep holes, and greatly reduce cutting friction and heat build-up.
- Ideal for drilling precise holes in soft and hard woods.
Hex-based pilot bits are intended to be used with a hex arbor adapter and hole saws. To minimize the risk of serious injury always use eye/respiratory protection and other PPE. Use the pilot bit and hole saw to drill only the materials listed on the product label. Make certain that the pilot bit is correctly sized for the hole saw being used. Always be sure that the drill bit protrudes above the saw teeth ¼” to 1” depending on the size of the saw. Follow RPM recommendations on the packaging for materials being cut and diameter of saw being used. Check the hole saw before use in the power tool – if excessive wear is present, the saw is bent, teeth are fractured or damaged, replace saw before use. Use a drill motor that is equipped with a support handle and start drilling with a light forward pressure. Important instructions and warnings are contained in the tool owner’s manual – please refer to the power tool owner’s manual before using the tool with this tool. Failure to heed all safety instructions, warnings, and in-use recommendations by the power tool manufacturer regarding the use of the reciprocating saw and blade could result in serious bodily injury.
HOLE SAWS ARE NOT TO BE USED IN HAMMER OR IMPACT MODE – only drill in standard rotary drilling mode or saw may become damaged/broken and may increase the likelihood of user injury.