Reciprocating Brushes

CARBON STEEL WIRE RECIPROCATING BRUSH

  • Fits Where Many Rotary Brushes Cannot
  • Tough carbon steel bristles remove the toughest contaminants like flaking paint, rust, dirt and much more
  • Use the power of a reciprocating saw to clean and prep surfaces in a fraction of time

NYLON RECIPROCATING BRUSH

  • Makes Clean-Up and Surface Prep a Snap
  • Durable nylon bristles provide tough cleaning power without scratching surfaces
  • Use the power of a reciprocating saw to clean and prep surfaces in a fraction of time

Selection Guide

Features

The reciprocating action of this narrow brush allows precision cleaning of large areas, in a fraction of the time of hand scrubbing. Clean into corners, along edges and follow grout lines where rotary brushes struggle to reach. Use with cleaners for additional cleaning power. Always use attachment parallel to the work surface – holding the reciprocating saw with the handle pointing away from the work surface may enable the attachment to become more parallel to the work surface, resulting in better tool operation.

CARBON STEEL WIRE Brush

  • Use on metals, concrete, stone and wood surfaces.
  • Tough carbon steel bristles remove the toughest contaminants.
  • Removes flaking paint, rust, scratches, dirt and small imperfections.
  • Fits all reciprocating saws.

Nylon Brush

  • Use on grout, carpet, tile, laminates, rubber, concrete, brick and more.
  • Nylon bristles provide tough cleaning power without scratching surfaces.
  • Makes quick work of stubborn layers of grime.
  • Fits all reciprocating saws.

Warning

To reduce the risk of injury, read the instruction manual and follow the safety regulations of the power tool you will be using with your Spyder accessory. Use personal protective equipment. Always wear eye protection. Protective equipment such as a dust mask, non-skid safety shoes, protective apparel and hearing protection should be used in appropriate conditions to reduce the risk of personal injury. WARNING: Operating the tool without wearing proper protection may result in serious injury. Before each use, make sure the brush is unbent and check the brush for wear, cracks, and other damage. Do not use an excessively worn or damaged brush as this can become stuck in the workpiece, cause kickback, create dangerous flying debris and/or create other unsafe situations that may cause injury. For better clearance from the workpiece, install the brush upside down.

WARNING
 RECIPROCATING BRUSHES ARE NOT TO BE USED IN ORBITAL MODE! Only use brushes with straight
reciprocating (non-orbital) action. Using the power tool in orbital mode can cause loss of control, damage the brush and the workpiece, and can increase the likelihood of user injury due to dangerous flying debris, tool kickback, and other unsafe situations.